D06 Dispenser

Features

• Block design to prevent leakage
• Grease and oil can be used
• High performance
• Possibility of different turrets for visual or electrical operation control by means of micro or proximity detector.
• Armored turret option
• Sturdy body in EN 10087-11SMnPb30
• Adjustable flow rate
• Caps available in methacrylate or aluminum

Description

The dispensers are lubrication elements designed for two simultaneous supply lines, one of them pressurized while the other is depressurized, alternating the lubrication cycles, thus dosing an adjustable quantity of lubricant in each cycle.

Design and principle of operation

Each dosing unit is composed of a servo piston and a servo piston (A) and a servo (B). The piston movements (Fig. 1) show the operation of the dispenser by alternating the lubricant feed when it enters through line 1 or when it enters through line 2.

The supply is made with the two separate outlets, but there is the possibility of internal communication of the outlets unifying them into a single outlet, thus doubling the flow rate. Two possibilities are available, through internal or external communication.

• Internal communication, it is carried out online and opposite outputs are communicated. Consists of removing the plug (C) and remove the ball from its interior. (D). (Fig. 2)
• External communication, outlets can be joined in line and are made by means of two additional parts on the outside, the junction block. (F) and the warhead (E). (Fig. 3)

As the communication is internal, we offer the advantage of avoiding external piping and fittings, thus favoring a clean installation.

Specifications